The Telematic Fault Preferred Job frame display a list of unit fault codes for a designated protocol. You can assign a Preferred Job Code and choose No Action or No Fault for each subsystem/element fault code.
The “no fault” setting is common for fault codes that are informational-only where no action would be required. M5 uses the following sequence to search for the preferred job to apply to the fault: Tech Spec Main, Category Main, Fault Preferred Job Frame and System Flags.
The parameters configured here will follow the fault code information into the Work Request and Work Order modules. Click on save when you are done.
System Flags
5206 - Default Job Codes for Inspecting ECM Faults - This job code is used as a default on a work request when ECU faults/alerts are active on a unit.
5207 - Default Job Reason for Inspecting ECM Faults - This job reason is used as a default on a work request when ECU faults/alerts are active on a unit.
For more information see the Vehicle Telematics Training Manual.
Last Updated: 03/28/2017
NOTE: To view a list of System Flags and Role Privileges that may impact this screen, hover over the screen title in M5 to display the bubble help/tooltip. At the bottom of the bubble help/tool tip, there is a Settings hyperlink. Click that hyperlink to display the list of flags and privileges.
Additional training and technical documents on this subject may be available in the Resource Files area.